Managed Switch CLI Manual, Release 8.0.3
Routing Commands 4-48
v1.0, July 2010
no area virtual-link dead-interval
This command configures the default dead interval for the OSPF virtual interface on the virtual
interface identified by <areaid> and <neighbor>. The <neighbor> parameter is the
Router ID of the neighbor.
area virtual-link hello-interval (OSPF)
This command configures the hello interval for the OSPF virtual interface on the virtual interface
identified by <areaid> and <neighbor>. The <neighbor> parameter is the Router ID of
the neighbor. The range for <seconds> is 1 to 65535.
no area virtual-link hello-interval
This command configures the default hello interval for the OSPF virtual interface on the virtual
interface identified by <areaid> and <neighbor>. The <neighbor> parameter is the
Router ID of the neighbor.
area virtual-link retransmit-interval (OSPF)
This command configures the retransmit interval for the OSPF virtual interface on the virtual
interface identified by <areaid> and <neighbor>. The <neighbor> parameter is the
Router ID of the neighbor. The range for seconds is 0 to 3600.
Format no area <areaid> virtual-link <neighbor> dead-interval
Mode Router OSPF Config
Default 10
Format area <areaid> virtual-link <neighbor> hello-interval <1-65535>
Mode Router OSPF Config
Format no area <areaid> virtual-link <neighbor> hello-interval
Mode Router OSPF Config
Default 5
Format area <areaid> virtual-link <neighbor> retransmit-interval <seconds>
Mode Router OSPF Config
To Next Page
Loading...
