NETGEAR GSM7228PS - Page 468

Managed Switch CLI Manual, Release 8.0.3
IPv6 Commands 7-58
v1.0, July 2010
The following OSPF NSSA specific information displays only if the area is configured as an
NSSA.
Format show ipv6 ospf area <areaid>
Modes • Privileged EXEC
• User EXEC
Term Definition
AreaID The area id of the requested OSPF area.
External
Routing
A number representing the external routing capabilities for this area.
Spf Runs The number of times that the intra-area route table has been calculated using this area's
link-state database.
Area Border
Router Count
The total number of area border routers reachable within this area.
Area LSA Count Total number of link-state advertisements in this area's link-state database, excluding AS
External LSAs.
Area LSA
Checksum
A number representing the Area LSA Checksum for the specified AreaID excluding the
external (LS type 5) link-state advertisements.
Stub Mode Represents whether the specified Area is a stub area or not. The possible values are
enabled and disabled. This is a configured value.
Import
Summary LSAs
Shows whether to import summary LSAs (enabled).
OSPF Stub
Metric Value
The metric value of the stub area. This field displays only if the area is a configured as a
stub area.
Term Definition
Import
Summary LSAs
Shows whether to import summary LSAs into the NSSA.
Redistribute
into NSSA
Shows whether to redistribute information into the NSSA.
Default
Information
Originate
Shows whether to advertise a default route into the NSSA.
Default Metric The metric value for the default route advertised into the NSSA.