Managed Switch CLI Manual, Release 8.0.3
Routing Commands 4-68
v1.0, July 2010
(Switch) #show ip ospf
Router ID.....................................2.2.2.2
OSPF Admin Mode...............................Disable
RFC 1583 Compatibility........................Enable
External LSDB Limit...........................No Limit
Exit Overflow Interval........................0
Spf Delay Time................................5
Spf Hold Time.................................10
Opaque Capability.............................Disable
AutoCost Ref BW...............................100 Mbps
Default Passive Setting.......................Disabled
Maximum Paths.................................4
Default Metric................................Not configured
Default Route Advertise.......................Disabled
Always........................................FALSE
Metric........................................Not configured
Metric Type...................................External Type 2
Number of Active Areas......................... 3 (3 normal, 0 stub, 0 nssa)
ABR Status....................................Disable
ASBR Status...................................Disable
Stub Router...................................FALSE
External LSDB Overflow........................FALSE
External LSA Count............................0
External LSA Checksum.........................0
AS_OPAQUE LSA Count...........................0
AS_OPAQUE LSA Checksum........................0
LSAs Originated...............................0
LSAs Received.................................0
LSA Count.....................................0
Maximum Number of LSAs........................18200
LSA High Water Mark...........................0
Retransmit List Entries........................ 9078
Maximum Number of Retransmit Entries........... 72800
Retransmit Entries High Water Mark............. 72849
To Next Page
Loading...
