Managed Switch CLI Manual, Release 8.0.3
IPv6 Multicast Commands 6-28
v1.0, July 2010
Example: The following shows example CLI display output for the command.
(Switch) #show ipv6 igmp-proxy groups
Interface Index................................ 1/0/3
Group Address Last Reporter Up Time Member State Filter Mode
Sources
------------- ---------------- ----------- ----------------- ------------- ----
---
FF1E::1 FE80::100:2.3 244 DELAY_MEMBER Exclude 2
Group Source List Expiry Time
------------------ ---------------
2001::1 00:02:40
2001::2 --------
FF1E::2 FE80::100:2.3 243 DELAY_MEMBER Include 1
Group Source List Expiry Time
------------------ ---------------
3001::1 00:03:32
3002::2 00:03:32
Field Description
Interface The interface number of the MLD-Proxy.
Group Address The IP address of the multicast group.
Last Reporter The IP address of the host that last sent a membership report for the current
group, on the network attached to the MLD-Proxy interface (upstream
interface).
Up Time (in secs) The time elapsed in seconds since last created.
Member State Possible values are:
• Idle_Member. The interface has responded to the latest group
membership query for this group.
• Delay_Member. The interface is going to send a group membership
report to respond to a group membership query for this group.
Filter Mode Possible values are Include or Exclude.
Sources The number of sources attached to the multicast group.
Group Source List The list of IP addresses of the sources attached to the multicast group.
Expiry Time The time left for a source to get deleted.
To Next Page
Loading...
