Managed Switch CLI Manual, Release 8.0.3
IPv6 Multicast Commands 6-20
v1.0, July 2010
When <group-address> is specified, the following fields are displayed for each multicast
group and each interface.
The following table is displayed to indicate all the sources associated with this group.
Example: The following shows examples of CLI display output for the commands.
(Switch) #show ipv6 mld groups ?
<group-address> Enter Group Address Info.
<unit/slot/port> Enter interface in unit/slot/port format.
(Switch) #show ipv6 mld groups 1/0/1
Group Address.................................. FF43::3
Interface...................................... 1/0/1
Up Time (hh:mm:ss)............................. 00:03:04
Expiry Time (hh:mm:ss)......................... ------
(Switch) #show ipv6 mld groups ff43::3
Interface...................................... 1/0/1
Group Address.................................. FF43::3
Last Reporter.................................. FE80::200:FF:FE00:3
Field Description
Interface Interface through which the multicast group is reachable.
Group Address The address of the multicast group.
Last Reporter The IP Address of the source of the last membership report received for this multicast
group address on that interface.
Filter Mode The filter mode of the multicast group on this interface. The values it can take are include
and exclude.
Version 1 Host
Timer
The time remaining until the router assumes there are no longer any MLD version-1 Hosts
on the specified interface.
Group Compat
Mode
The compatibility mode of the multicast group on this interface. The values it can take are
MLDv1 and MLDv2.
Field Description
Source Address The IP address of the source.
Uptime Time elapsed in hours, minutes, and seconds since the source has been known.
Expiry Time Time left in hours, minutes, and seconds before the entry is removed.
To Next Page
Loading...
