Managed Switch CLI Manual, Release 8.0.3
Captive Portal Commands 12-9
v1.0, July 2010
redirect-url
Use this command to configure the redirect URL for a captive portal configuration. The url is the
URL for redirection which can be up to 512 characters in length.
max-bandwidth-down
Use this command configures the maximum rate at which a client can receive data from the
network. The rate is in bits per seconds. 0 indicates limit not enforced.
no max-bandwidth-down
Use this command to reset the maximum rate to the default.
max-bandwidth-up
Use this command to configure the maximum rate at which a client can send data into the
network. The rate is in bits per seconds. 0 indicates limit not enforced.
Format no redirect
Mode Captive Portal Instance mode
Format redirect-url url
Mode Captive Portal Instance mode
Default 0
Format max-bandwidth-down <0-536870911>
Mode Captive Portal Instance mode
Format no max-bandwidth-down
Mode Captive Portal Instance mode
To Next Page
Loading...
