Managed Switch CLI Manual, Release 8.0.3
Captive Portal Commands 12-10
v1.0, July 2010
no max-bandwidth-up
Use this command to reset the maximum rate to the default.
max-input-octets
Use this command to configure the maximum number of octets the user is allowed to transmit.
After this limit has been reached the user will be disconnected. The number of octets is in bytes. 0
indicates limit not enforced.
no max-input-octets
Use this command to reset the limit to the default.
Default 0
Format max-bandwidth-up <0-536870911>
Mode Captive Portal Instance mode
Format no max-bandwidth-up
Mode Captive Portal Instance mode
Default 0
Format max-input-octets <0-4294967295>
Mode Captive Portal Instance mode
Format no max-input-octets
Mode Captive Portal Instance mode
To Next Page
Loading...
