Managed Switch CLI Manual, Release 8.0.3
IPv6 Commands 7-49
v1.0, July 2010
enable (OSPFv3)
This command resets the default administrative mode of OSPF in the router (active).
no enable (OSPFv3)
This command sets the administrative mode of OSPF in the router to inactive.
exit-overflow-interval (OSPFv3)
This command configures the exit overflow interval for OSPF. It describes the number of seconds
after entering Overflow state that a router will wait before attempting to leave the overflow state.
This allows the router to again originate non-default AS-external-LSAs. When set to 0, the router
will not leave overflow state until restarted. The range for <seconds> is 0 to 2147483647
seconds.
no exit-overflow-interval(OSPFv3)
This command configures the default exit overflow interval for OSPF.
Default enabled
Format enable
Mode Router OSPFv3 Config
Format no enable
Mode Router OSPFv3 Config
Default 0
Format exit-overflow-interval
<seconds>
Mode Router OSPFv3 Config
Format no exit-overflow-interval
Mode Router OSPFv3 Config
To Next Page
Loading...
