Managed Switch CLI Manual, Release 8.0.3
Switching Commands 3-75
v1.0, July 2010
The show dot1x detail <unit/slot/port> command will display the following MAC-
based dot1x fields if the port-control mode for that specific port is MAC-based. For each client
authenticated on the port, the
show dot1x detail <unit/slot/port> command will display
the following MAC-based dot1x parameters if the port-control mode for that specific port is MAC-
based.
If you use the optional parameter statistics <unit/slot/port>, the following dot1x
statistics for the specified port appear.
Maximum Users The maximum number of clients that can get authenticated on the port in the MAC-based
dot1x authentication mode. This value is used only when the port control mode is not
MAC-based.
Unauthenticate
d VLAN ID
Indicates the unauthenticated VLAN configured for this port. This value is valid for the
port only when the port control mode is not MAC-based.
Session
Timeout
Indicates the time for which the given session is valid. The time period in seconds is
returned by the RADIUS server on authentication of the port. This value is valid for the
port only when the port control mode is not MAC-based.
Session
Termination
Action
This value indicates the action to be taken once the session timeout expires. Possible
values are Default, Radius-Request. If the value is Default, the session is terminated the
port goes into unauthorized state. If the value is Radius-Request, then a reauthentication
of the client authenticated on the port is performed. This value is valid for the port only
when the port control mode is not MAC-based.
Term Definition
Supplicant
MAC-Address
The MAC-address of the supplicant.
Authenticator
PAE State
Current state of the authenticator PAE state machine. Possible values are Initialize,
Disconnected, Connecting, Authenticating, Authenticated, Aborting, Held,
ForceAuthorized, and ForceUnauthorized.
Backend
Authentication
State
Current state of the backend authentication state machine. Possible values are Request,
Response, Success, Fail, Timeout, Idle, and Initialize.
VLAN-Assigned The VLAN assigned to the client by the radius server.
Logical Port The logical port number associated with the client.
Term Definition
To Next Page
Loading...
