Managed Switch CLI Manual, Release 8.0.3
Switching Commands 3-171
v1.0, July 2010
lldp transmit
Use this command to enable the LLDP advertise capability.
no lldp transmit
Use this command to return the local data transmission capability to the default.
lldp receive
Use this command to enable the LLDP receive capability.
no lldp receive
Use this command to return the reception of LLDPDUs to the default value.
lldp timers
Use this command to set the timing parameters for local data transmission on ports enabled for
LLDP. The <interval-seconds> determines the number of seconds to wait between
transmitting local data LLDPDUs. The range is 1-32768 seconds. The <hold-value> is the
Default enabled
Format lldp transmit
Mode Interface Config
Format no lldp transmit
Mode Interface Config
Default enabled
Format lldp receive
Mode Interface Config
Format no lldp receive
Mode Interface Config
To Next Page
Loading...
