Managed Switch CLI Manual, Release 8.0.3
Stacking Commands 2-2
v1.0, July 2010
member
This command configures a switch. The <unit> is the switch identifier of the switch to be
added/removed from the stack. The <switchindex> is the index into the database of the
supported switch types, indicating the type of the switch being preconfigured. The switch index is
a 32-bit integer. This command is executed on the Primary Management Unit.
no member
This command removes a switch from the stack. The <unit> is the switch identifier of the
switch to be removed from the stack. This command is executed on the Primary Management Unit.
switch priority
This command configures the ability of a switch to become the Primary Management Unit. The
<unit> is the switch identifier. The <value> is the preference parameter that allows the user
to specify, priority of one backup switch over another. The range for priority is 1 to 15. The switch
with the highest priority value will be chosen to become the Primary Management Unit if the
active Primary Management Unit fails. The switch priority defaults to the hardware management
preference value 1. Switches that do not have the hardware capability to become the Primary
Management Unit are not eligible for management.
Format member <unit> <switchindex>
Mode Stack Global Config
Note: Switch index can be obtained by executing the show supported switchtype
command in User EXEC mode.
Format no member <unit>
Mode Stack Global Config
Default enabled
Format switch <unit> priority <value>
Mode Global Config
To Next Page
Loading...
