Managed Switch CLI Manual, Release 8.0.3
IP Multicast Commands 5-2
v1.0, July 2010
ip mcast boundary
This command adds an administrative scope multicast boundary specified by <groupipaddr>
and <mask> for which this multicast administrative boundary is applicable. <groupipaddr> is
a group IP address and <mask> is a group IP mask.
no ip mcast boundary
This command deletes an administrative scope multicast boundary specified by
<groupipaddr> and <mask> for which this multicast administrative boundary is applicable.
<groupipaddr> is a group IP address and <mask> is a group IP mask.
ip multicast
This command sets the administrative mode of the IP multicast forwarder in the router to active.
no ip multicast
This command sets the administrative mode of the IP multicast forwarder in the router to inactive.
Format ip mcast boundary <groupipaddr> <mask>
Mode Interface Config
Format no ip mcast boundary <groupipaddr> <mask>
Mode Interface Config
Default disabled
Format ip multicast
Mode Global Config
Format no ip multicast
Mode Global Config
To Next Page
Loading...
