Managed Switch CLI Manual, Release 8.0.3
Utility Commands 9-20
v1.0, July 2010
logging console
This command enables logging to the console. You can specify the <severitylevel> value as
either an integer from 0 to 7 or symbolically through one of the following keywords: emergency
(0), alert (1), critical (2), error (3), warning (4), notice (5), info (6), or debug
(7).
no logging console
This command disables logging to the console.
logging host
This command enables logging to a host. You can configure up to eight hosts. The
<ipaddr|hostname>
is the IP address of the logging host. The <addresstype>
indicates the type of address ipv4 or ipv6 or dns being passed. The <port> value is a port number from 1
to 65535. You can specify the <severitylevel> value as either an integer from 0 to 7 or
symbolically through one of the following keywords: emergency (0), alert (1), critical
(2), error (3), warning (4), notice (5), info (6), or debug (7).
Default disabled; critical when enabled
Format logging console [severitylevel]
Mode Global Config
Format no logging console
Mode Global Config
Default • port—514
• level—critical (2)
Format logging host <ipaddr|hostname> <addresstype>
[<port>][<severitylevel>]
Mode Global Config
To Next Page
Loading...
