Managed Switch CLI Manual, Release 8.0.3
Utility Commands 9-42
v1.0, July 2010
client-name
This command specifies the name for a DHCP client. Name is a string consisting of standard
ASCII characters.
no client-name
This command removes the client name.
default-router
This command specifies the default router list for a DHCP client. {address1, address2…
address8} are valid IP addresses, each made up of four decimal bytes ranging from 0 to 255. IP
address 0.0.0.0 is invalid.
no default-router
This command removes the default router list.
Default none
Format client-name <name>
Mode DHCP Pool Config
Format no client-name
Mode DHCP Pool Config
Default none
Format default-router <address1> [<address2>....<address8>]
Mode DHCP Pool Config
Format no default-router
Mode DHCP Pool Config
To Next Page
Loading...
