10-1
v1.0, July 2010
Chapter 10
Management Commands
This chapter describes the management commands available in the managed switch CLI.
The Management Commands chapter contains the following sections:
• “Configuring the Switch Management CPU” on page 10-2.
• “Console Port Access Commands” on page 10-8.
• “Telnet Commands” on page 10-11.
• “Secure Shell (SSH) Commands” on page 10-16.
• “Management Security Commands” on page 10-19.
• “Hypertext Transfer Protocol (HTTP) Commands” on page 10-20.
• “Access Commands” on page 10-28.
• “User Account Commands” on page 10-29.
• “SNMP Commands” on page 10-40.
• “RADIUS Commands” on page 10-52.
• “TACACS+ Commands” on page 10-67.
• “Configuration Scripting Commands” on page 10-71.
• “Pre-login Banner and System Prompt Commands” on page 10-73.
Warning: The commands in this chapter are in one of three functional groups:
• Show commands display switch settings, statistics, and other information.
• Configuration commands configure features and options of the switch. For every
configuration command, there is a show command that displays the configuration
setting.
• Clear commands clear some or all of the settings to factory defaults.
To Next Page
Loading...
