NETGEAR GSM7228PS - Page 714

Managed Switch CLI Manual, Release 8.0.3
Log Messages 11-13
v1.0, July 2010
IGMP Snooping Failed to set igmp mrouter mode %d for
interface xxx on Vlan yyy
Failed to set VLAN multicast router mode
due to IGMP Snooping message queue
being full
IGMP Snooping snoopCnfgrInitPhase1Process: Error
allocating small buffers
Could not allocate buffers for small IGMP
packets
IGMP Snooping snoopCnfgrInitPhase1Process: Error
allocating large buffers
Could not allocate buffers for large IGMP
packets
Table 11-24: GARP/GVRP/GMRP Log Messages
Component Message Cause
GARP/GVRP/
GMRP
garpSpanState, garpIfStateChange,
GarpIssueCmd, garpDot1sChangeCallBack,
garpApiCnfgrCommand,
garpLeaveAllTimerCallback,
garpTimerCallback: QUEUE SEND
FAILURE:
The garpQueue is full, logs specifics of the
message content like internal interface
number, type of message etc.
GARP/GVRP/
GMRP
GarpSendPDU: QUEUE SEND FAILURE The garpPduQueue is full, logs specific of
the GPDU, internal interface number, vlan
id, buffer handle etc.
GARP/GVRP/
GMRP
garpMapIntfIsConfigurable,
gmrpMapIntfIsConfigurable: Error accessing
GARP/GMRP config data for interface %d in
garpMapIntfIsConfigurable.
A default configuration does not exist for this
interface. Typically a case when a new
interface is created and has no pre-
configuration.
GARP/GVRP/
GMRP
garpTraceMsgQueueUsage: garpQueue
usage has exceeded fifty/eighty/ninety
percent
Traces the build up of message queue.
Helpful in determining the load on GARP.
GARP/GVRP/
GMRP
gid_destroy_port: Error Removing port %d
registration for vlan-mac %d -
%02X:%02X:%02X:%02X:%02X:%02X
Mismatch between the gmd (gmrp
database) and MFDB.
GARP/GVRP/
GMRP
gmd_create_entry: GMRP failure adding
MFDB entry: vlan %d and address %s
MFDB table is full.
Table 11-25: 802.3ad Log Messages
Component Message Cause
802.3ad dot3adReceiveMachine: received default
event %x
Received a LAG PDU and the RX state
machine is ignoring this LAGPDU
Table 11-23: IGMP Snooping Log Messages
Component Message Cause