NETGEAR GSM7228PS - Page 744

Managed Switch CLI Manual, Release 8.0.3
Captive Portal Commands 12-16
v1.0, July 2010
If the interface is specified. The following term will be displayed.
Example
(Switch)#show captive-portal configuration 1 interface
CP ID..................................... 1
CP Name................................... cp1
Operational Block
Interface Interface Description Status Status
--------- --------------------- ---------------- ----------1/0/1
Unit:1Slot:0Port:1 Disabled Blocked
(Switch)#show captive-portal configuration 1 interface 1/0/1
CP ID..................................... 1
CP Name................................... cp1
Interface................................. 1/0/1
Interface Description..................... Unit: 1 Slot: 0 Port: 1 Gigab
Operational Status........................ Disabled
Disable Reason............................ Interface Not Attached
Block Status.............................. Not Blocked
Authenticated Users....................... 0
Term Definition
CP ID The captive portal ID.
CP Name The captive portal name.
Interface The interface associated with the CP ID
Interface
Description
The interface description
Operational Status The operational status is enabled or disabled.
Disable Reason The reason if the operational status is disabled.
Block Status It shows this captive portal instance block all traffic or not.
Term Definition
Authenticated
users
The number of authenticated users associated with the CP ID.