Toshiba GR200 Series - (iii) Delayed pick-up;delayed drop-off signal; (iv) Logic level inversion

6F2S1914 (0.49)
GRL200 (Soft 033 & 037)
- 1090 -
LED-03
[Input signal 1]
[LOGIC-SW]
AND
OR
XOR
&
≥1
=1
&
Off
Dwell
Delay
&
&
Blink
≥1
Blink
&
DRIVER
Latch
&
F/F
[TIMER-SW]
0.000-300.000s
3100031001
31001A100
[Input signal 2]
[Input signal 3]
[Input signal 8]
0
t
[Logic Timer]
[Reset signal]
LED indicator #3
[Input signal 1]
[LOGIC-SW]
AND
OR
XOR
&
≥1
=1
&
Off
Dwell
Delay
&
&
Blink
≥1
Blink
&
DRIVER
Latch
&
F/F
[TIMER-SW]
0.000-300.000s
LED-04
3100041001
[Input signal 2]
[Input signal 3]
[Input signal 8]
0
t
[Logic Timer]
[Reset signal]
[Input signal 1]
[LOGIC-SW]
AND
OR
XOR
&
≥1
=1
&
Off
Dwell
Delay
&
&
Blink
≥1
Blink
&
DRIVER
Latch
&
F/F
[TIMER-SW]
0.000-300.000s
LED-26
[Input signal 2]
[Input signal 3]
[Input signal 8]
0
t
[Logic Timer]
[Reset signal]
LED indicator #4
LED indicator #26
1
[INVERSE-SW]
&
&
Inverse
Normal
t
0
0.000-300.000s
0
t
0.000-300.000s
[On Delay Timer]
[Off Delay Timer]
1
1
[INVERSE-SW]
&
&
Inverse
Normal
t
0
0.000-300.000s
0
t
0.000-300.000s
[On Delay Timer]
[Off Delay Timer]
1
1
[INVERSE-SW]
&
&
Inverse
Normal
t
0
0.000-300.000s
0
t
0.000-300.000s
[On Delay Timer]
[Off Delay Timer]
1
Figure 5.6-2 LED indicator logics (#3 to #26)
(iii) Delayed pick-up/delayed drop-off signal
For the LED indicator logic #3 the user can use an on-delay timer and an off-delay timer; both
are used to adjust the timing for lighting the LED indicator #3. The user should set their
respective time values for settings [On Delay Timer] and [Off Delay Timer].
(iv) Logic level inversion
On the LED indicator logic #3 the entering signal is inverted by the logic inversion function;
inverting an entering signal is carried out when the user sets Inverse for the scheme switch
[INVERSE-SW]. Set Normal for the scheme switch when logic inversion is not required.