Toshiba GR200 Series - 3.8 Mode control function (MDCTRL)

6F2S1914 (0.49)
GRL200 (Soft 033 & 037)
- 609 -
Mode control function (MDCTRL)
For the user, mode control (MDCTRL) function can provide test function (TEST-FB) interface,
which is a command to change the mode in the function. MDCTRL function consists of two
parts: (1) On-mode or Test-mode sensing in IED and (2) interface between IED and SAS.
─────────────────────────────────────────────────────────────────
Note: The implementation of particular features is dependent upon the selection of
hardware and the configuration of functions. Several IED models do not support certain
features. To determine whether a particular feature has been implemented within an IED,
identify the IED ordering number; and check the order number for the “G&T position” whilst
referring to the comparison table below. For more information, see Appendix: Ordering .
Table 3.8-1 Comparative table in respective ordering numbers
Sec.
Feature
Ordering No. at “G&T”
33
37
–
Main features
✓
✓
✓: Applicable NA: Not applicable