Toshiba GR200 Series - (iii) Operate condition

6F2S1914 (0.49)
GRL200 (Soft 033 & 037)
- 776 -
(iii) Operate condition
Figure 4.4-11 shows the operate condition logic, which is used to examine a reset-condition in
the OPTIM function.
Operate condition
OPTIM function (Function ID: 529001)
To operate logic
Control hierarchy (e.g. 43RL) (PLC connection point) *5
IED serious error detected
[OPTR1_EN]
On
Users must setup this condition correctly
Function “Automatic sequence control” is in progress
CBK_STATE
Command blocking*1
Double Command Blocking detected*2
Other devices traveling detected*3
DCB RCV OR
Traveling OR
ASEQ_MULTI_SEL
OPTR01_CTRL_RIGHT
529001 820C01ED50
SERI_ERR
&
&
1≥
Unmatched condition detected *4
Figure 4.4-11 Operate condition logic in OPTIM
*1to5
Note: The signals and settings of the Figure 4.4-11 are same as the ones of the
Figure 4.4-6.