EasyManua.ls Logo

Toshiba GR200 Series - 4.1.2 Cancel logic for SBO mode; (i) Receiving “Cancel” from the remote-end; (i)-1 Input point required mapping; (i)-2 Output signal to BO

Toshiba GR200 Series
1770 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
6F2S1914 (0.49)
GRL200 (Soft 033 & 037)
- 635 -
4.1.2 Cancel logic for SBO mode
In SBO control mode the reception of a cancel command is possible; the function can discard
the select command when the cancel conditions are satisfied; finally, the operation returns to
the initial stage (i.e., waiting state Wait for a command.)
(i) Receiving “Cancel” from the remote-end
Figure 4.1-14 depicts the cancel command procedure for a cancel command initiated from the
remote-end.
Signal reception in
IEC61850
Cancel from remote-end
Do nothing
Cancel
decision
Success
Failed
Cancel logic
Wait for a command
Operate logic
Operate command
Operate logic
Select logics
Cancel from front panel
Select command Off from remote-end
Select command On from remote-end
Select command Off from front panel
Select On from front panel
Select command On by the PLC
function
Select command Off by the PLC
function
Wait for a next command
Figure 4.1-14 Outline of ‘cancel command from the remote-end
Input point required mapping
Figure 4.1-15 depicts the cancel logic when a Cancel command (Remote-Cancel) signal is
applied to the SPOS01 function. The input-point “DEV01_CONTROL_REQ” is the same as
that for the signal Select command On (Remote-On-Control).
SPOS01 function (Function ID: 510001)
“SPOS01_ CC_SS (510001_8601011E95)
DEV01_CONTROL_REQ
Cancel command
Command Remote-cancel
510001_7001016D08
510001 7001016D08
Input
Output
Cancel logic in SPOS01
Cancel condition
&
&
Successes to cancel
Operation Failed
“SPOS01_CC_FS (510001_8701011E96)
Do nothing
To Wait for a command
Figure 4.1-15 ‘Cancel’ from the remote-end in SPOS01
Note: The logic cancel conditionis shown in Figure 4.1-18
Output signal to BO
The SPOS01 function can issue an output signal Success to cancel at the monitoring point
SPOS01_CC_SS, when the SPOS01 function has determined that the Remote-cancel signal

Table of Contents

Related product manuals