Toshiba GR200 Series - (iv) Operate time of DT; (iv)-1 Time characteristic; (iv)-2 Instantaneous activation; (v) Reset time for IDMT

6F2S1914 (0.49)
GRL200 (Soft 033 & 037)
- 248 -
Figure 2.16-3 IDMT Characteristics curves
(iv) Operate time of DT
The operate time in the DT is a constant.
Time characteristic
The user should set DT for the scheme switch [EF1-Timer]. The value of the required operate
time is set for the setting [TEF1] in the range 0.00–300.00s.
Instantaneous activation
The instantaneous operation characteristic is achieved by setting zero for the [TEF1], but the
instantaneous one can be also obtained when the logic signal ‘1(High)” is programmed to be
injected at the PLC connection point “EF1_INST_OP”.
(v) Reset time for IDMT
Programming the reset time characteristic is available for the IEEE standard, US standard
and original (user-programmable) inverse-time-reset characteristic†. In the IEEE standard,
for example, the user can set DEP for the scheme switch [EF1-Rtimer]. The following equation