Toshiba GR200 Series - (i) Receiving “change value for counter” from the remote-end; (i)-1 Mapping of Input point required; (i)-2 Output signal to BO; (ii) Receiving “change value for counter” from the local-end

6F2S1914 (0.49)
GRL200 (Soft 033 & 037)
- 959 -
“TPOS_Dev1-P3”, respectively. The “TPOS_Dev1-All” represents the net counter
of “TPOS01_ST_P1”, “TPOS01_ST_P2” and “TPOS01_ST_P3”.
(i) Receiving “change value for counter” from the remote-end
Mapping of Input point required
Figure 4.9-47 depicts the logic when a “change value for counter” command is received at the
TPOS01 function. With regard to the net counter, the input-point “DEV01_ALLCNT_REQ” is
used. With regard to a P1-control counter, the input-point “DEV01_P1CNT_REQ” is used. For
P2-control and P3-control, the input-points “DEV01_P2CNT_REQ” and “DEV01_P3CNT_REQ”
are used.
TPOS01 function (Function ID: 513001)
Operate Command
DEV01_ALLCNT_REQ
Command “change value for counter”
513001_7004016D09
&
“TPOS01_SLD_CSCN”
(513001 8A04011F8B)
Input
Output
Operate logic in TPOS01
Operate condition‡
Figure 4.9-47 Change counter value in net counter
†
by the remote-end in TPOS01
‡Note: The “operate condition” signal is provided from the operate condition logic shown
in Figure 4.9-49.
†
Note: The user can apply the other counter change commands for P1-control, P2-control
and P3-control as shown in Table 4.9-24. The resultant signals for the other
TPOS02-24 logics are shown in Table 4.9-23.
Output signal to BO
The TPOS01 function can issue a “Result” signal at output point “TPOS01_SLD_CSCN”.
(ii) Receiving “change value for counter” from the local-end
Input signal from the front panel
Figure 4.9-48 depicts the logic when a “change value for counter” command is provided in the
TPOS01 function. The command is provided from the sub-menu (see Figure 4.9-46).
TPOS01 function (Function ID: 513001)
“TPOS01_SLD_CSCN”
(513001 8A04011F8B)
Input
Output
Operate logic in TPOS01
Command “Change value”
Figure 4.9-48 Changing value by the operation of the front panel in TPOS01