- 1354 -
(ii) Choice of 61850 edition number
Select IEC 61850 tool from the menu of Configuration tool, as shown in Figure 11.3-8. When
the user can see the edition list†, select a required one from the list‡. Then, the user can see
the edition number at the header on IEC61850 tool screen, or the bottom of the GR-TIEMS
main screen.
Selection of IEC61850 tool
Figure 11.3-8 Choice of IEC61850 edition number
†Note: When the user has purchased the products supporting for Editon1-Option or later
edition, the GR-TIEMS can display the Edition list menu, as shown in Figure
11.3-8; thus, the user should select one from the edition list. However, if neither is
supported in your products, then the menu is not displayed, and default Edition1
will be selected directly. The user can check it through the IED screen if the IED
has Edition1_Option or later edition. See sec 11.3.3(vi) for the confirmation.
Regarding ‘Edition1_Option’, see section 11.3.1(ii) and 11.3.9.
‡Note: Be aware that your edition selection cannot be undone. If you fail to select a
correct one, make the project again. You are not able to change the edition after
the choice.
To Next Page
Loading...
