Toshiba GR200 Series - 4.5 Total time measurement function (TOTALTIM)

6F2S1914 (0.49)
GRL200 (Soft 033 & 037)
- 783 -
Total time measurement function (TOTALTIM)
The total time measurement function (TOTALTIM) measures the time of the On state using a
signal which is selected with the logic programmed by the PLC function. The TOTALTIM
function increments the time for which the signal is in the “ON” state and stores it as a
cumulative time. The TOTALTIM function can monitor up to 12 signals simultaneously. This
function also has correction processes.
─────────────────────────────────────────────────────────────────
Note: The implementation of such features depends on the selection of hardware and the
configuration of functions. Several IED models do not have its features. To determine whether
its features are implemented in the IED, locate the IED ordering number; and check the order
number at the “G&T position” referring to the comparison table below. For more information,
see Appendix: Ordering .
Table 4.5-1 Comparative table in respective ordering numbers
Sec.
Feature
Ordering No. at “G&T”
33
37
–
Main features
NA
✓
–
Number of functions
–
12
✓: Applicable NA: Not applicable