- 1498 -
(vii) White-plastic-sheets for IED case sides
When the user wishes to mount an IED case in the 19-inch rack, the user should have
arrangements and preparations of the IED in advance. There are two types with regard to the
structures of IED cases.
Rack mounting type: flanges have to be screwed and fixed on the case, and countersunk screws
are provided for them. When wishing to place the IED case in a 19-inch rack, put white-
plastics-sheets on the countersunk screws to cover up (see Figure 13.3-7); they are bundled in
its package. Detach the flange from the case if combining cases is required with a mounting
kit. Remind that the user needs to put the white-plastic-sheet over the countersunk screws on
each side.
Figure 13.3-7 Covering the screw holes with white plastic sheets
Note: When the case is ordered in 1/1 size one; the flange is integrated so that the
countersunk screws and white-plastic-sheets are not provided.
Note: For more information about how to mount a case in a rack, see
Installation
handbook for rack mounting, cable work, etc.
(6F2S1954)
.
The user can get a
mounting kit by ordering (
see Appendix: Ordering
).
Flush-mounting type: flanges are integrated at the both sides of the case. Thus, the white-
plastics-sheets are not bundled.
To Next Page
Loading...
