- 1367 -
(v) Writing the configuration file to IED
When the user has completed editing the configuration files, the user can write the
IEC61850 configuration files, as shown in
Figure 11.3-23 Write to IED
Follow the below steps to write the file in the IED.
1. Save the current project in the PC.
2. Right click on the target IED and select “Write to IED”.
3. Click items to write: Signal list†, GOOSE Subscribe†, CID, and
Mapping Data.
4. Click Write to transfer the files to the IED.
Figure 11.3-24 Selection of CFD writing items
†Note: If GOOSE subscribe operation is required, the user shall select Signal List and
GOOSE Subscribe.
To Next Page
Loading...
