- 727 -
4.2.8 Setting
DPSY01(FunctionID:511001)
Number of Event lock detect time
Timer of detect event lock
Timer of recovery from event lock
Normally Open Signal of the single-pole or
phase A
Normally Close Signal of the single-pole or
phase A
Normally Open Signal of phase B
Normally Close Signal of phase B
Normally Open Signal of phase C
Normally Close Signal of phase C
Normally Open contact grouping
Normally Close contact grouping
Automatic event suppression function
undefined pallet check function
palette undefined check timer
faulty pallet check function
palette faulty check timer
control mode (control enable)
Synchronism Check Apply or Bypass
control action(Direct or SBO)by HMI
select binary output read data(DataID)1 for no
direction command
select binary output read data(DataID)2 for no
direction command
select binary output read data(DataID) for off
direction select command
select binary output read data(DataID) for on
direction select command
execute binary output read data(DataID) for
off direction execute command
execute binary output read data(DataID) for
on direction execute command
To Next Page
Loading...
