Toshiba GR200 Series - (iii) Binary output; (iii)-1 Selection of binary output circuit: For example, Figure 12.6-8 illustrates the selection of a binary output circuit on a binary IO module. Move the cursor by pressing keys ▲ and ▼. Press key ► to go to the next level in the hierarchy.; (iii)-2 CPL Setting: For example, Figure 12.6-9 illustrates the setting of a binary output circuit (BO1). Using setting [BI1_CPL] On, the CPL logic in BO1 is available. Similarly, assigned signals, timers and switches can be set in this menu. Note tha...

6F2S1914 (0.49)
GRL200 (Soft 033 & 037)
- 1469 -
(iii) Binary output
All binary output circuits provided in the IED are also user-configurable; the user can configure
timers and switches using CPL settings. (For more information of CPL, see Chapter Technical
description: Binary IO module: Binary output circuit )
Selection of binary output circuit: For example, Figure 12.6-8 illustrates the
selection of a binary output circuit on a binary IO module. Move the cursor by
pressing keys ▲ and ▼. Press key ► to go to the next level in the hierarchy.
Figure 12.6-8 Selection of slot and binary output circuit
Note: This screen is a sample. The slot numbers displayed are dependent upon the
configuration of the binary IO module in each IED case.
CPL Setting: For example, Figure 12.6-9 illustrates the setting of a binary
output circuit (BO1). Using setting [BI1_CPL] On, the CPL logic in BO1 is
available. Similarly, assigned signals, timers and switches can be set in this
menu. Note that detailed setting items are shown when On is keyed into
setting [BI*_CPL].
Binary Output
10:48 2/3
Slot#1 >
_Slot#2 >
Slot#3 >
[►]
Slot#2
10:48 1/10
_BO1 >
BO2 >
BO3 >
BO4 >
BO5 >
BO6 >