Toshiba GR200 Series - 11 Communication protocol

6F2S1914 (0.49)
GRL200 (Soft 033 & 037)
- 1322 -
11 Communication protocol
Contents
Pages
Pages
IEC 60870-5-103 operation
–
LAN operation
–
-Interface
1400
-IP address
1324
-Interoperability
1403
-Hot standby operation
1325
-Operation
1424
-PRP/HSR operation
1333
IEC 61850 operation
1343
-RSTP operation
1337
-About protocol
1345
-Monitoring (Hot standby)
1327
-Communication service
1348
-Monitoring (PRP/HSR)
1335
-Engineering work
1351
-Goose monitoring status
1380
Selection of slave protocol
1323
-Protocol selection
1372
RS485operation
1429
-Quality signal
1373
USB operation
1428
-Setting
1370
-Supervise
1372
-61850 Editon1 option
1347
-61850 Editon2
1347
─────────────────────────────────────────────────────────────────
Note: The implementation of such protocols depends on the selection of protocols. Several
IED models do not have the protocols. To determine whether the protocols are implemented in
an IED, locate its IED ordering code, and check it at the “U” position referring to the
comparison table below. For more information, see Appendix: Ordering .
Table Comparative table in respective ordering codes
Sec.
Ordering codes
Position “U”
1
2
11.3
IEC 61850
✓
1
11.4
IEC 60870-5-103
✓
2
NA
✓: Applicable NA: Not applicable
1
LAN modules, designed for PRP/HSR/RSTP marked with “L or N” code at position “E”, shall
be selected and mounted in the IED, if the network requires PRP/HSR/RSTP operation.
2
One of protocols (i.e., either 61850 or 103) shall be selected before the in-service operation.