Toshiba GR200 Series - (vi) IP setting example [RedundantMode]=PRP or HSR

6F2S1914 (0.49)
GRL200 (Soft 033 & 037)
- 1336 -
(vi) IP setting example [RedundantMode]=PRP or HSR
When PRP or HSR is set for the setting [RedundantMode], the user can apply single IP address
in the IED. The table below shows that both Port A and B have the same IP address.
Table 11.2-6 Default IP address for PRP/HSR operation
Protocol
IEC61850(GOOSE)
SNTP
GR-TIEMS® /
MULTIPLOG®
IP address at
Port A†
192.168.1.11
192.168.1.11
192.168.1.11
IP address at
Port B†
†Note: Address ‘192.168.1.11’ is set as default. Either port A or B is allowed to operate.