- 884 -
DPOS72 change command received. (Mapping Data) for 3-phase counter value
DPOS01 change command received. (Mapping Data) for A-phase counter value
DPOS02 change command received. (Mapping Data) for A-phase counter value
DPOS03 change command received. (Mapping Data) for A-phase counter value
DPOS72 change command received. (Mapping Data) for A-phase counter value
DPOS01 change command received. (Mapping Data) for B-phase counter value
DPOS02 change command received. (Mapping Data) for B-phase counter value
DPOS03 change command received. (Mapping Data) for B-phase counter value
DPOS72 change command received. (Mapping Data) for B-phase counter value
DPOS01 change command received. (Mapping Data) for C-phase counter value
DPOS02 change command received. (Mapping Data) for C-phase counter value
DPOS03 change command received. (Mapping Data) for C-phase counter value
DPOS72 change command received. (Mapping Data) for C-phase counter value
Table 4.8-24 Results of changing counter
DPOS01 select command for Binary Output.
DPOS02 select command for Binary Output.
DPOS03 select command for Binary Output.
DPOS20 select command for Binary Output.
(v) Setting name
Table 4.8-25 Setting for operation counter in DPOSxx
Mode selection of the counter in DPOSxx
NA / C-On / C-Off / C-OnOff
To Next Page
Loading...
