Toshiba GR200 Series - 5.7 Clock function; 5.7.1 Clock setting; 5.7.2 Selection of date and time formats

6F2S1914 (0.49)
GRL200 (Soft 033 & 037)
- 1102 -
Clock function
Clock function (or time function) provides the time information for recording upon occurrence
of the fault; it includes a synchronization function when the reference clock is available out of
the IED. The clock is operated referring the Coordinated Universal Time (UTC‡) when the
UTC is selected; the clock can run in accordance with the user’s time zone and summer
time(DST)† by referring the UTC when the time zone and the DST are set. The explanation is
also found in Chapter User interface: Time sub-menu .
†Note: In other words, it is called “daylight saving time (DST)”. For setting, see section
5.7.5.
‡Note: For example, the Internet and World Wide Web standards run in the UTC. For
more information, see section 5.7.4.
5.7.1 Clock setting
The user can set the time using the time sub-menu as shown in Figure 5.7-1. The user also can
set the time using the GR-TIEMS†.
Clock
10:00 1/2
[Time] +
2012-11-21 10:00:05
[Format]
YYYY-MM-DD HH:mm:ss
[ActiveSyncSrc] >
SNTP
Figure 5.7-1 Time sub-menu in Clock menu
†Note: Make the calibration the when the clock is set using the GR-TIMES. This is
because the transmission time is required from the PC to the IED.
5.7.2 Selection of date and time formats
The user can select user-preferred date/time format; setting [Data_fmt] is provided for the
selection of the format. For example, ‘March 24th 2014 10:48’ can be displayed when the format
“DDMMYYYY” is selected.
• “2014-03-24 10:48” is displayed upon the selection of “YYYYMMDD”.
• “03-24-2014 10:48” is displayed upon the selection of “MMDDYYYY”.
• “24-03-2014 10:48” is displayed upon the selection of “DDMMYYYY”.
Display Format
10:48 1/4
Date_fmt +
YYYYMMDD
Date_delimiter +
-
Time_delimiter +
:
Figure 5.7-2 Setting screen of Display format