Toshiba GR200 Series - (ii)-2 CPL setting: Figure 12.6-6 is an example of a “Common” setting. From this screen, the user can set a threshold level and the number of comparisons feature for contact chatter for all binary input circuits.

6F2S1914 (0.49)
GRL200 (Soft 033 & 037)
- 1468 -
Figure 12.6-5 Selection of slot and binary input circuit
Note: This screen is a sample. The slot numbers displayed depend upon the
configuration of the binary IO module in each IED.
CPL setting: Figure 12.6-6 is an example of a “Common” setting. From this
screen, the user can set a threshold level and the number of comparisons
feature for contact chatter for all binary input circuits.
Figure 12.6-6 Common screen
For example, Figure 12.6-7 shows the CPL setting for binary input circuit (BI1).
The timer and the inverse switch can be activated when On is set for setting
[BI1_CPL]. Press key ENTER to commence the setting of a switch or parameter.
Figure 12.6-7 CPL setting
Note: Setting items “On Delay timer and others” are displayed when the user sets
[BI*_CPL] On.
Binary Input
10:48 2/3
Slot#1 >
_Slot#3 >
Slot#4 >
[►]
Slot#3
10:48 1/8
_Common >
BI1 >
BI2 >
BI3 >
BI4 >
BI5 >
Common
10:48 1/2
Thres_Level +
Low
Cmp_Num +
4
BI1
10:48 1/2
BI1_CPL +
Off
On Delay Timer +
0.000 s
Off Delay Timer +
0.000 s
SW
Inverse-SW +
Normal