Toshiba GR200 Series - (iii)-2 SNTP menu; (iii)-3 BI SYNC menu

6F2S1914 (0.49)
GRL200 (Soft 033 & 037)
- 1476 -
SNTP menu
IP address of SNTP server can be set by the following procedure.
Figure 12.7-9 SNTP
(1) Confirm that the SNTP synchronization function has been set for
On. Subsequently move cursor to the SNTP menu and press ►.
(2) Move cursor to desired server number and press ENTER.
(3) The user can set IP address using ▲ or ▼ by each digit.
When the user has finished setting IP address of the server, press
ENTER.
BI SYNC menu
When the “BI SYNC” is set to On in Time Sync menu, the user can choose a binary input circuit
(BI) as a synchronization standard. Adjustment setting ‘SYNC_ADJ’ is provided.
Binary synchronization function can be set by the following procedure.
Figure 12.7-10 BISYNC
(1) Enter the Data ID of the BI output
(2) Set adjustment time for [SYNC ADJ]
Time Sync
10:48 1/3
TimeSyncSrc +
SNTP
_SNTP +>
On
BI SYNC +>
Off
SNTP
10:48 1/4
_Server1 +
0. 0. 0. 0
Server2 +
0. 0. 0. 0
Server3 +
0. 0. 0. 0
SNTP
10:48 1/4
Server1 +
0. 0. 0.
176
Server2 +
0. 0. 0. 0
Server3 +
0. 0. 0. 0
BI SYNC
10:48 1/2
BI_ID +
No Assign
SYNC_ADJ +
0.000 s