Toshiba GR200 Series - (v) Statistics; (v)-1 Power Value sub-menu: With regard to statistics item, the name and its value are shown below. The user can also change the unit of each value by the setting1. It is allowed to reset or revise the statistics value2.

6F2S1914 (0.49)
GRL200 (Soft 033 & 037)
- 1448 -
Figure 12.4-9 Steps to display the status of measuring elements
(v) Statistics
“Statistics” sub-menu has several sub-menus.
Figure 12.4-10 Menu hierarchy for Statistics
For each statistical item, with the exception of displaying their status, the data can be
reset or revised.
Power Value sub-menu: With regard to statistics item, the name and its value
are shown below. The user can also change the unit of each value by the
setting
1
. It is allowed to reset or revise the statistics value
2
.
Figure 12.4-11 Display of Power Value
Table 12.4-1 Operation means for data reset or data revise
Step
Display
Operation key
Remark
1
[>]
►
Press ► key to go to the sub-menu
2
[+]
ENTER
Press ENTER key to execute reset or revise. After
executing, a confirmation dialog screen displays.
1
Note: In order to secure the reliability, the reset and revision items are controlled by the
vendor.
2
Note: The number of digits for the power value can be reduced based on the units kW,
MW and kvar+. For instance, when the power is measured as "123,456kW" then it
is displayed as "123MW". If this value has to be changed then the user can key in a
new compensated value. For example, if "78MW" should be displayed on the IED
screen even though the measured value is "123,456kW" then the user should key in
Monitoring
Statistics
Power value
Accumulated Time
Sub-menu Sub-menu Sub-menu
Operation Time
Operation Counter
Total Time
Counter
Power Value
10:48 1/4
W
h+ +
0.0MWh
Wh- +
0.0MWh
varh+ +
0.0Mvarh