- 663 -
✓ SBOw
✓ Oper
✓ Cancel
✓ Origin
✓ stSeld
✓ sboClass† (choice ”operate-once”)
✓ ctlmodel (choice ”SBOes or SBOns” )
†”sboClass” can be found by scrolling down.
Figure 4.1-41 LN editing screen for SBO (for example)
Defining DIR setting mode
Figure 4.1-42 exemplifies the SPOS01 logic node saved as “GGIO1501”. In the DIR mode, the
following three items should be selected using GR-TIEMS:
✓ Oper
✓ origin
✓ ctlmodel (choice ”DOes or DOns” )
Figure 4.1-42 LN editing screen for DIR mode (for example)
(ii) Mapping output data
The user should group the SPOS01 signals with regard to GOOSE and Report; the user should
map them for IEC 61850 communication using GR-TIEMS. Figure 4.1-43 illustrates how to
map a signal; it indicates that the signals for the SPOS01 function are required to be mapped
for IEC 61850 communication.
To Next Page
Loading...
