- 980 -
4.9.8 Setting
TPOS01(FunctionID:513001)
Number of Event lock detect time
Timer of detect event lock
Timer of recovery from event lock
TPOS01 switch for Device01
state name of (0,0,0)state
state name of (0,0,1)state
state name of (0,1,0)state
state name of (0,1,1)state
state name of (1,0,0)state
state name of (1,0,1)state
state name of (1,1,0)state
state name of (1,1,1)state
P1 Normally Open Signal of Dev1
P2 Normally Open Signal of Dev1
P3 Normally Open Signal of Dev1
Automatic event suppression function
undefined pallet check function
palette undefined check timer
faulty pallet check function
palette faulty check timer
control mode (control enable)
control action(Direct or SBO)by HMI
select binary output read data(DataID)1 for no
direction command
select binary output read data(DataID)2 for no
direction command
select binary output read data(DataID)3 for no
direction command
select binary output read data(DataID) for P1
direction command
select binary output read data(DataID) for P2
direction command
select binary output read data(DataID) for P3
direction command
execute binary output read data(DataID) for
P1 direction command
execute binary output read data(DataID) for
P2 direction command
execute binary output read data(DataID) for
P3 direction command
Change logic about control condition
To Next Page
Loading...
