Toshiba GR200 Series - Page 183

6F2S1914 (0.49)
GRL200 (Soft 033 & 037)
160
ZS (Function ID： 430001）
Setting items
Range
Unit
Contents
Default
Note
1A rating
5A rating
1A
5A
Z1XS-
MhoR.EN
Off / On
-
Z1XS resistive reach use or not (for Mho)
Off
Z1XS-R.Angle
30 - 90
deg
Z1XS resistive reach characteristic angle
75
Z1XS-R.Reach
0.10 -
500.00
0.01 -
100.00
-
Z1XS resistive reach
25.50
5.10
Z1XS-
MhoDX.EN
Off / On
-
Z1XS directional-X characteristic use or not
(for Mho)
Off
Z1XS-DX.Angle
0 - 60
deg
Z1XS directional-X characteristic angle
30
Quad
Z1XS-X.Reach
0.10 -
500.00
0.01 -
100.00
-
Z1XS reactance reach
12.00
2.40
Z1XS-
X.GrAngleEN
Off / On-Set / On-
Adapt
-
ZS gradient characteristic
Off
Z1XS-R.Angle
30 - 90
deg
Z1XS resistive reach characteristic angle
75
Z1XS-R.Reach
0.10 -
500.00
0.01 -
100.00
-
Z1XS resistive reach
25.50
5.10
Z1XS-DX.Angle
0 - 60
deg
Z1XS directional-X characteristic angle
30
Z1XS-DR.Angle
0 - 60
deg
Z1XS directional-R characteristic angle (for
Quad)
5
TZ1XS
0.00 - 100.00
s
Z1XS operation delay time
0.00
Z1XS-CovCoeff
1.5 - 10.0
-
Covered characteristic size coefficient
1.5
Output
Z1XS-MSDET
Off / On
-
Multi-phase or non-earth-fault condition is
used or not
On
Z1XS-PSBBlk
Non / Block
-
Z1XS operation block or not by PSB detection
Block
Z1XS-LEBlk
Non / Block
-
Z1XS blocked or not by Load encroachment
Non
Z1XS-ARCBlk
Non / Block
-
Autoreclose execution block by Z1XS-trip
Non
Z1XS-OCFS-
EN
Off / On
-
Fail-safe OC for Z1XS-trip
Off
OCF1XS
0.02 - 5.00
0.10 -
25.00
A
Fail-safe OC operation level for Z1XS-trip
0.20
1.00
Z1XS-SOTF
Off / On
-
SOTF using Z1XS
Off
Note 1: On-Adapt is only applicable when Forward is set for ZS.
Note 2: When On-Adapt is set for the scheme switch [Z*S-X.GrAngleEN], the setting
value [ZSF-X.GrAngle1] will be calculated by itself. However, the user should
enter a value for [ZSF-X.GrAngle2] regardless of the setting of the [ZS-
X.GrAngleEN].