- 614 -
Table 3.8-5 Mapping signals required for LLNO object in MDCTRL01 function
System/LLN0$Mod$SBOw$origin
System/LLN0$Mod$SBOw$origin
System/LLN0$Mod$Oper$origin
System/LLN0$Mod$Oper$origin
System/LLN0$Mod$Cancel$origin
System/LLN0$Mod$Cancel$origin
†Note: The attribute is defined in the IEC 61850 standard; “CO” stands for “Control”
and “CF” stands for “Configuration” in the functional constraint (FC).
Figure 3.8-5 Input-point mapped for LLNO
To Next Page
Loading...
