Managed Switch CLI Manual, Release 8.0.3
IPv6 Commands 7-43
v1.0, July 2010
no area virtual-link(OSPFv3)
This command deletes the OSPF virtual interface from the given interface, identified by
<areaid> and <neighbor>. The <neighbor> parameter is the Router ID of the neighbor.
area virtual-link dead-interval (OSPFv3)
This command configures the dead interval for the OSPF virtual interface on the virtual interface
identified by <areaid> and <neighbor>. The <neighbor> parameter is the Router ID of
the neighbor. The range for <seconds> is 1 to 65535.
no area virtual-link dead-interval(OSPFv3)
This command configures the default dead interval for the OSPF virtual interface on the virtual
interface identified by <areaid> and <neighbor>. The <neighbor> parameter is the
Router ID of the neighbor.
area virtual-link hello-interval (OSPFv3)
This command configures the hello interval for the OSPF virtual interface on the virtual interface
identified by <areaid> and <neighbor>. The <neighbor> parameter is the Router ID of
the neighbor. The range for <seconds> is 1 to 65535.
Format no area <areaid> virtual-link <neighbor>
Mode Router OSPFv3 Config
Default 40
Format area <areaid> virtual-link <neighbor> dead-interval
<seconds>
Mode Router OSPFv3 Config
Format no area <areaid> virtual-link <neighbor> dead-interval
Mode Router OSPFv3 Config
Default 10
Format area <areaid> virtual-link <neighbor> hello-interval
<seconds>
Mode Router OSPFv3 Config
To Next Page
Loading...
