Managed Switch CLI Manual, Release 8.0.3
IPv6 Commands 7-44
v1.0, July 2010
no area virtual-link hello-interval(OSPFv3)
This command configures the default hello interval for the OSPF virtual interface on the virtual
interface identified by <areaid> and <neighbor>. The <neighbor> parameter is the
Router ID of the neighbor.
area virtual-link retransmit-interval (OSPFv3)
This command configures the retransmit interval for the OSPF virtual interface on the virtual
interface identified by <areaid> and <neighbor>. The <neighbor> parameter is the
Router ID of the neighbor. The range for <seconds> is 0 to 3600.
no area virtual-link retransmit-interval(OSPFv3)
This command configures the default retransmit interval for the OSPF virtual interface on the
virtual interface identified by <areaid> and <neighbor>. The <neighbor> parameter is
the Router ID of the neighbor.
area virtual-link transmit-delay (OSPFv3)
This command configures the transmit delay for the OSPF virtual interface on the virtual interface
identified by <areaid> and <neighbor>. The <neighbor> parameter is the Router ID of
the neighbor. The range for <seconds> is 0 to 3600 (1 hour).
Format no area <areaid> virtual-link <neighbor> hello-interval
Mode Router OSPFv3 Config
Default 5
Format area <areaid> virtual-link <neighbor> retransmit-interval
<seconds>
Mode Router OSPFv3 Config
Format no area <areaid> virtual-link <neighbor> retransmit-interval
Mode Router OSPFv3 Config
Default 1
To Next Page
Loading...
