Managed Switch CLI Manual, Release 8.0.3
Quality of Service (QoS) Commands 8-20
v1.0, July 2010
assign-queue
This command modifies the queue id to which the associated traffic stream is assigned. The
queueid is an integer from 0 to n-1, where n is the number of egress queues supported by the
device.
drop
This command specifies that all packets for the associated traffic stream are to be dropped at
ingress.
mirror
This command specifies that all incoming packets for the associated traffic stream are copied to a
specific egress interface (physical port or LAG).
Format assign-queue <queueid>
Mode Policy-Class-Map Config
Incompatibilities Drop
Format drop
Mode Policy-Class-Map Config
Incompatibilities Assign Queue, Mark (all forms), Mirror, Police, Redirect
Note: This command is not available on the GSM7328Sv1or GSM7352Sv1 platforms.
Format mirror <unit/slot/port>
Mode Policy-Class-Map Config
Incompatibilities Drop, Redirect
To Next Page
Loading...
