Managed Switch CLI Manual, Release 8.0.3
Quality of Service (QoS) Commands 8-21
v1.0, July 2010
redirect
This command specifies that all incoming packets for the associated traffic stream are redirected to
a specific egress interface (physical port or port-channel).
conform-color
Use this command to enable color-aware traffic policing and define the conform-color class map.
Used in conjunction with the police command where the fields for the conform level are specified.
The <class-map-name> parameter is the name of an existing DiffServ class map.
class
This command creates an instance of a class definition within the specified policy for the purpose
of defining treatment of the traffic class through subsequent policy attribute statements. The
<classname> is the name of an existing DiffServ class.
Note: This command is not available on the GSM7328Sv1 or GSM7352Sv1 platforms.
Format redirect <unit/slot/port>
Mode Policy-Class-Map Config
Incompatibilities Drop, Mirror
Note: This command may only be used after specifying a police command for the policy-
class instance.
Format conform-color <class-map-name>
Mode Policy-Class-Map Config
Note: This command causes the specified policy to create a reference to the class
definition.
To Next Page
Loading...
