Toshiba GR200 Series - Page 1486

6F2S1914 (0.49)
GRL200 (Soft 033 & 037)
- 1463 -
On any screen, press the screen-jump function key to display a screen, refer to the
following figure:
Figure 12.5-14 Operation of screen jump function
To cancel the screen-jump function, follow the procedure provided in Figure 12.5-15.
Note: 1) Once a screen is configured to a function key, it will not be deleted until a new
screen is configured for the same function key.
2) If a configured screen is disabled by “On/Off Function” setting (refer to section
12.5(iii)), the screen jump function is also disabled for the function key.
Figure 12.5-15 Cancelling screen jump function
OC
10:48 1/4
_OC1EN +>
On
OC2EN +>
On
OC3EN +
Off
[
F1
]
Main Menu
10:48 2/8
Record >
_Monitoring >
Setting >
IO setting >
Time >
Test >
[
F1
]
F1 Key Function
10:48 3/3
Screen Jump
Assign Signal
_No Assign
[►]
[ENTER]
Setting
Change Setting?
ENTER=Yes CANCEL=No
Function Key
10:48 1/7
F1 Key >
F2 Key >
F3 Key >
F4 Key >
F5 Key >
F6 Key >
[ENTER]
[▲] x 2
F1 Key
10:48 1/3
*Function +
No Assign
Signal +
No Assign
Logic
Instant +
F1 Key Function
10:48 1/3
*Screen Jump
Assign Signal
No Assign
[◄]
[◄] x 2
F1 Key
10:48 1/3
Function +
Screen Jump
Signal +
No Assign
Logic
Instant +
[ENTER]
[CANCEL]
The “Screen Jump” function is
canceled on F1 key.
[▼] x 2