Toshiba GR200 Series - Page 1506

6F2S1914 (0.49)
GRL200 (Soft 033 & 037)
- 1483 -
description: Binary IO Module )
Figure 12.8-5 Binary input menu
Figure 12.8-6 is a case when IO#3 (Slot#03) is selected.
Figure 12.8-6 Setting menu for Slot #3 module
For example, if the user wishes to simulate binary input circuit #1 (BI1) on the
BIO1A module at IO#3 slot, the user can select SLOT3-BI01-SET screen, as shown
in Figure 12.8-6).
Figure 12.8-7 Setting menu after selecting “Slot #3-BIO1-SET”
The user can then make the following selections on the screen and configure the
items required for simulation.
• ON: BI1 output is set forcibly to ON(Logic level=high(1)) regardless of
the actual input signal.
• OFF: BI1 output is set forcibly to OFF(Logic level=low(0)) regardless of
the actual input signal.
• Normal: Actual inputs are applied.
Use the screen shown in Figure 12.8-7 only to configure the BI signals for the
Binary Input
10:48 1/2
Slot#1 >
Slot#3 >
Slot#3
10:48 1/19
BIF OP +
Slot3-BIO1-SET +
Normal
Slot3-BIO2-SET +
Normal
Slot3-BI03-SET +
Slot3-BIO1-SET
10:48 1/3
Normal
Off
On