Change place and contents
Revised the details of the information sub-menu
Deleted the panel cut out figure for ‘Ring lug type
terminal’; deleted the case outline for ‘1/3 case’
Added the 103 protocol interoperability
Added the 103 protocol choice; deleted the selection of
the Ring lug type terminal in Ordering
Revised the combination about relay applications in the
model ‘34’ and ‘35’ in Ordering
Deleted the Ring lug type terminal in ‘Terminal block
specification’
Added the communication specification using the rear
serial ports in IEC103 protocol
Revised the LAN interface and technical specification
Added the setting for the 2term terminals in
COMM_APPL
Added new section for the control hierarchy
Added the DCB feature again in CMNCTRL; modify
the contents
Revised the signal coming from the control hierarchy in
L/R control
Revised the signal coming from the control hierarchy in
LEDR
Revised the signal coming from the control hierarchy in
GCNT
Added the monitoring signals in MDCTRL
Revised the signal numbers and their names about the
SPOS
Revised the signal numbers and their names about the
DPSY
Revised the number of functions and their names about
the SOFTSW
Added the control hierarchy signal in the OPTIM
Revised the signal list in TOTALTIM
Revised the signal numbers and their names in
SYNDIF
Revised the signal list in ILK
Revised the signal numbers and their names in DPOS
Revised the signal numbers and their names in TPOS
Revised the signal numbers and their names in ASEQ
Added FG cable for BI2A module
Revised the example logics for the group setting
function
To Next Page
Loading...
