Change place and contents
Corrected the name of DUVFS, TDUVFS, and DUVFS-
EN in Fig. 2.29-3
Corrected typos in setting lists (VTF)
Corrected a delay timer value and add NOT operation
in Fig. 2.31-1. Revised a setting content (CTF)
Corrected typos in Equations 2.32-15, -16, -19, -21 in
FL function
Corrected typos of OPT signals in Figure 2.33.5 at TRC
function
Added the test operation contents in COMM_APPL
Added the test operation content in CLP
Added the contents about the setting of edition
selection in IEC61850
Added the operation contents about test settings
Added configuration exercise for CB control
Revised the outlines about Setting tables in respective
protection applications
Corrected incorrect figure about generator locations in
Fig. 2.10-3
Revised the contents about MPFBlk setting in ZG
elements in Sec. 2.10.3 (iii)-2
Revised the content about setting PSBSFR in ZS/ZG
elements in Sec. 2.10.4 (i)-1
Deleted the testing content and added Z1S,Z1XS, Z5S
zone enhancements in Sec. 2.10.6 (iii)-4
Corrected typos in Z1S common in Fig. 2.10-36,-44,-45,-
46,-47,-48,-49
Revised the default setting at Z*G-LPBlk settings
Added the contents about reset and OC in PSB; rev.
Fig.2.10-26; rev. logics in Fig.2.10-27,28 in ZS/ZG
Corrected incorrect logic connecting lines in Figs. 2.12-
3, 2.12-5, 2.12-6, 2.12-12
Added signals for POP signals in Fig. 2.12-4; Corrected
incorrect logics
Corrected incorrect entering signal name in Fig. 2.12-8
Revised the contents of reset time of IDMT and reset
illustration of Fig. 2.15-7 in OC function
Revised the contents of reset time of IDMT and reset
illustration of Fig. 2.16-5 in EF function
Revised the contents of reset time of IDMT and reset
illustration of Fig. 2.17-5 in OCN function
Corrected the number of decimal places about curve
coefficient in Table 2.21-2 in OV function
Corrected the number of decimal places about curve
coefficient in Table 2.22-2 in OVS function
Corrected the number of decimal places about curve
coefficient in Table 2.23-2 in OVG function
To Next Page
Loading...
