Change place and contents
Corrected a typo in Note of Figure 2.7-1 in RDIF
Added the notice regarding the data contents at N=3
extended frame
Revised the contents about IEDs arrangement and
setup in DIF_COMM
Corrected the upside-down arrows on communication
channel in Figure 2.36-7 in DIF_COMM
Corrected a typo about switch [TERM_TOPOLPGY]
Add ‘properly’ at the end of contents about Multiplexer
setting
Correct not matched contents in settings
‘COM_WIDTH’, T.SFT’, ‘B.SYN’, and ‘TCDT’
Corrected the incorrect the flame name ‘C37.93’ to
‘C37.94’ in Table 2.37.2, -3, and -4 in COMM_APPL
Revised the IP addresses settings and their setting
examples for Hot stand-by, PRP, and HSR operations
Corrected typos regarding IEEE number applied in
RSTP protocol (IEEE802.1D)
Added the contents about LED testing using arrow
keys on the front panel
Corrected typo and revised the contents at INF=19
(LED reset) in information list
Corrected the function block name at Voltage check for
autoreclosing (SYNC→VCHK)
Deleted unused P and R code in the tables about BIO
modules
Corrected a plus/minus typo in equation (2.2-8) in DIFL
Added RYBLK-CH signals in Fig. 2.2-3 and the
contents about the relay block signals
Corrected connection lines at DUV-DIFL and the
names (DIFL-DUV-EN, UV-EN, UVS-EN) in Fig. 2.2-4
Added the test operation contents in Stub-DIFL
function
Added the test operation content in Stub-OC function
Added zero-sequence compensation logics in Z1G,
Z1XG, and Z5G in Fig. 2.10-44/45/49
Added the test operation content in ZS and ZG
functions
Added the test operation content in SOTF-OC function
Corrected incorrect the names of EN items in setting
lists (EF*-EN)
Revised information about Retrip settings (2.20.2 and
2.20.5) and corrected typos in Fig. 2.20-2 (CBF)
Added PLC connection points in Fig. 2.20-2 (CBF)
Added the test operation content in UV
Added the test operation content in UVS
To Next Page
Loading...
