Change place and contents
Refined the signal list used for TIEMS, fault recording
and IEC61850 in Monitoring function
Corrected a typo about the error level of HMI automatic
supervision function (Table 10.2-1)
Revised the information about PSW error in Automatic
supervision function
Added the information about the IEC61850 CID file for
the Goose and LAN settings
Corrected the information of outlines with regard to the
codes (F, J at Position 9).
Corrected the logics of Echo operations in Fig. 2.13-7
and 2.13-8 in DISCAR function
Corrected OC1 scheme logic about the instantaneous
operation in Fig. 2.15-8
Revised and corrected timers and PLC connection
points in Figure 4.6-10, 11, 14, 15 and 16 in SYNDIF
Revised the PWS information about Fail contacts and
AC power supply
Added the information about dielectric voltage test
when 24-60Vdc PWS is used in the IED.
Revised “Calculation in Z*G-CovCoeff” in section
2.10.6
Revised “ZG logic” in section 2.10.7
Revised section 2.21.1 for characteristics and settings
Revised section 2.22.1 for characteristics and settings
Revised section 2.23.1 for characteristics and settings
Revised section 2.24.1 for characteristics and settings
Revised section 2.25.1 for characteristics and settings
Revised section 2.37-2 and -3.
J. Yamamoto/
Y. Ohtake
May. 8
Archive: 6F2S1914 G2A) 0.0088.docx
To Next Page
Loading...
